Zeiss N HBO 103 Specifiche Scaricare il pdf (Pagina 38)

SETTING UP THE INSTRUMENT

Carl Zeiss Attaching the condensers Axio Observer

38 B 46-0111 e 12/06

3.5.5 Fitting the gliding stage Z

The gliding stage is fitted in the same way as the heating stage using three spacer disks.

• Before attaching the gliding stage to the stand, the three support elements on the underside of the

gliding stage must be unscrewed.

• Place spacer disks on the three attachment points of the stand.

• Place the gliding stage on the stand and screw in place using the three Allen screws from above.

Ensure that each screw passes through the hole in the relevant spacer disk.

If the gliding stage is used, the nosepiece must be lowered fully using the focus drive before

changing objectives - otherwise the objective may collide with the gliding stage.

Tilt the transmitted light illuminator carrier back into the working position.

3.6 Attaching the condensers

3.6.1 Condensers for the Axio Observer

• Insert the condenser (3-16/1) into the

condenser carrier on the transmitted light

illuminator carrier with the fitting facing

upwards. Ensure that the locating pin on the

condenser is at the front and engages precisely

with the guide groove on the condenser carrier.

• Fix the condenser in place using the locking

screw (

3-16/2).

• If motorized condensers are used, connect the

cable to the socket on the left of the carrier.

WARNING

Where the incubator PM S1 or incubator micromanipulation S1 are used, there is a risk of

glass breakage. Always fit the condenser with the transmitted light illuminator carrier tilted

backwards. After fitting, tilt the mount carefully back into the forward position, taking care

not to damage the glass of the incubator. If necessary, lift the condenser carrier to the highest

position.

Fig. 3-16 Attaching the condenser

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 129 130

Nessun commento

Zeiss N HBO 103 Specifiche Pagina 38